Lamp outage / hyperflash disable for LED bulbs — F-150 FORScan mod (2011–2014)
Turns off front and/or rear bulb-outage detection so LED turn bulbs don't hyper-flash.
- Module
- BCM — Body Control Module (726)
- Model years
- 2011 2012 2013 2014
- Category
- Lighting
- Risk
- Low risk
- FORScan setting
- No named setting documented. Use As-Built Format.
- As-Built
BCM 726-13-01: x*x* xxxx xx (front: 0=outage off, 1=on, change both *)
BCM 726-14-01: x*x* xxxx xx (rear stop/turn: 0=off, 1=on)As published by the source below. Compare against your own backup; surrounding digits control other features.
Notes
You lose the dash/hyperflash warning for a genuinely burned-out bulb.
How to apply it
- Back up every module's As-Built data and keep the files somewhere safe.
- Connect FORScan with a battery maintainer on, ignition ON and engine OFF.
- Open Configuration and Programming, choose the BCM module, open As-Built Format and edit only the digit described by the source.
- Write, follow any module reset prompt, cycle the ignition, then confirm the feature and check for new trouble codes.